Assembly; Operation - Hart HPHL66 Manual Del Operador

ASSEMBLY

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.

OPERATION

WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from
a distance). Staring into the light beam may result in
serious injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Operate in a well ventilated area. Do not block vents.
Keep them clear to allow proper ventilation.
APPLICATIONS
You may use this product for the purposes listed below:
 To illuminate distant objects and areas requiring
additional light
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 6.
Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place

and the battery pack is secured in the product before
beginning operation.
Depress the latch and pull to release and remove the

battery pack.
If the light flashes during operation, try recharging and
reinstalling the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Battery products are always in operating condition.
Therefore, remove the battery pack when the product is
not in use or when carrying at your side
TURNING THE SPOTLIGHT ON AND OFF
See Figure 2, page 6.
The spotlight has four settings: high, medium, low, and off.
 High: Press the switch trigger once.
 Medium: Press the switch trigger twice.
 Low: Press the switch trigger a third time.
 Off: Press the switch trigger a fourth time.
TO HANG THE SPOTLIGHT
See Figure 3, page 7.
WARNING:
Only hang or mount spotlight in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang the
light from any electrical power cord. Ensure spotlight is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
Using the dual orientation mounting hook to hang the
spotlight:
 T he mounting hook is located at the top rear of the
spotlight.
 U se the mounting hook to hang the light. Do not suspend
the light from electrical wires.
NOTE: Be careful not to hang the light in such a way that
it prevents normal light operation.
Using the mounting hole to hang the light:
 A mounting hole is located at the rear of the spotlight.
 H ang spotlight from sturdy location by inserting a nail
into the mounting hole to secure in place.
NOTE: Be careful not to hang the light in such a way that
it prevents normal light operation.
4 – English