Hunter Argenus 30580 Manual Del Usuario página 10

Air Sterilizer Maintenance
Cleaning the Pre-Filter and Changing the Main Filter (cont.)
3. Reset the Main Filter Life Counter by pressing the Main Filter Reset Button.
See Figure 9.
NOTES:
• Make certain the Pre-Filter, the Main Filter, and the Top Cover are installed cor-
rectly.
• The Air Sterilizer will not operate if the Top Cover is either off of the unit,
or is not installed correctly on the unit.
To return the Air Sterilizer to service:
1. Reinstall the Top Cover. Place the Tabs on the back of the Top Cover into
the corresponding holes in the Base. Then, move the front of the Top Cover
downward. See Figure 10.
2. Plug the unit into a standard household electrical outlet.
3. Turn the Fan Speed Control Dial to Medium. (You can select your desired fan
speed after you verify fan operation.) The Fan should begin operating and the
Power LED should illuminate. Verify fan operation by placing your hand at
the top/back of the unit. You should feel air moving. If the fan does not begin
operating, go to the Troubleshooting section on page 12 of this manual.
43006-01
Fan Speed Control Dial
(Top Cover Removed)
Fig. 9 - Resetting the Main Filter Life Counter
Fig. 10 - Reinstalling the Top Cover
Main Filter
Reset Button
1
2
10