SAD EAS1010 Instrucciones De Instalación página 8

EAS1010
Set the Activation Code Length
Access the programming mode, then:
Press "*" and "9": the indicator will flash yellow; then press "0" and "4": a beep will be heard, then enter
X(X=2,3,4,5,6):
2 stands for the number of digits in the code: the code will comprise 2 digits (00-99).
3 stands for the number of digits in the code: the code will comprise 3 digits(000-999).
And so on... Admin codes can contain up to 6 digits.
A beep sound will be heard, indicating that the code length was successfully saved.
If 3 beeps are heard, the code length is the same as the existing length and the new setting is not
permitted.
Press "#" to exit the setting menu.
CAUTION: Once the activation code length is changed, all previously saved codes will be deleted.
Add a User Code (ZONE 1)
Access the programming mode, then:
Enter a 3-digit number from 000 to 999 and the indicator will flash:
1. If the indicator lights up red: data have already been saved in this unit; press "*" twice to clear it.
2. If the indicator lights up green: this code may be added to the defined passwords.
Activation code addition procedure:
1. Access the programming mode; the yellow indicator will flash.
2. Enter a 3-digit number from 000 to 999, and the green indicator will light up.
3. Enter the activation code. The code length should be the same as the admin code.
For example, the admin code is 12 (two is the length). Therefore a 2-digit code will need to be set; you
can define 00 to 99 codes.
If the admin code is 123 (three is the length), a 3-digit code will need to be set, you can define 000 to 999
codes.
And so on.
A beep sound will indicate that the code has been added successfully.
Press "#" to exit the setting menu.
Add a User Code (ZONE 2)
Access the programming mode, then:
Press "*" and "4": the yellow indicator will flash; enter a 2-digit number from 00 to 10 and the yellow
indicator willflash.
1. If the indicator lights up red: data have already been saved in this unit; press "*" twice to clear it.
2. If the indicator lights up green: this code may be added to the defined codes.
Activation code addition procedure:
Enter the relevant code. The code length should be the same as the admin code.
For example, the admin code is 12 (two is the length). Therefore a 2-digit code will need to be set; you
can define 00 to 99 codes. If the admin code is 123 (three is the length), a 3-digit code will need to be set;
you can define 000 to 999 codes.
And so on.
A beep sound will indicate that the code has been added successfully.
Press "#" to exit the setting menu.
WARNING:The user code must be different from the administration code.
The code for ZONE 1 must be different from ZONE 2.
ENGLISH
8 ENGLISH
9