Human Touch JADE Manual De Uso Y Cuidado página 6

INSTALL THE CONTROL PANEL AND CONNECT THE JADE HEAT PAD
1. Install the body pad onto the chair seat and footrest, with the backrest pad folded forward onto
the seat (Fig.12).
2. Connect the transformer cable to both the control panel cable and the jade heat pad cable (the connections are
color-coded), slide the connector cover over the connections, then tuck the cables into the seat canvas (Fig.12).
Control panel cable
Connector cover
Transformer cable
Jade heat pad cable
Fig.12
3. Using a Phillips-head screwdriver, remove the three screws that secure the left-hand armrest cap
to the chair, then remove the armrest cap (Fig.13).
4. Place the control panel bracket on top of the armrest core (Fig.14).
Armrest cap
Armrest core
Fig.13
humantouch.com
Control panel
Backrest pad
Center mounting bracket
between screw holes
Fig.14
8
5. Replace the armrest cap, then secure it using the three screws (Fig.15).
6. Using a Phillips-head screwdriver, remove the screw that secures the glide rail safety tip.
Discard this screw (Fig.16).
7. Place the cable loop into position over the screw hole, place the provided washer over the cable loop,
then secure the assembly using the provided screw (Fig.16).
8. Reinstall the body pad onto the chair.
9. Plug the Jade Heat cord into a wall outlet.
Armrest cap
Glide rail safety tip
Fig.15
USING YOUR JADE HEAT SYSTEM
Press the heat button to toggle through low, medium, high, and off.
Be sure to turn off your jade heat system when not in use.
Low Medium High
Screw
Washer
Cable loop
Fig.16
9