Install The Hardware; Mount The Video Encoder; Connect The Cables; Access The Video Stream - Axis Q7411 Guia De Instalacion

AXIS Q7411 Installation Guide

Install the hardware

!
IMPORTANT! - The casing of the AXIS Q7411 is not approved for outdoor use - the
product may only be installed in indoor environments.

Mount the video encoder

The video encoder is supplied with a mounting kit containing screws and plugs for mounting the
video encoder to a concrete wall:
1. Place the video encoder against the wall, and mark the location of the four mounting holes (see
page 6) through which the video encoder will be attached.
2. Remove the video encoder and drill the four mounting holes.
3. Insert the wall plugs into the wall, position the video encoder, and attach it to the wall using
the screws provided.
The supplied protective pads can be used to avoid scratching the surface on which the video
encoder is placed. Punch out the pads and apply them to the underside of the video encoder.

Connect the cables

1. Connect the encoder to the network using a shielded network cable. If using PoE see note
below.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 8 for information
on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the camera to the video input.
5. If powering the unit with the DC input, connect the supplied indoor power adapter or an
external power supply. See note below.
6. Check that the indicator LEDs indicate the correct conditions. See the table on page 11 for
further details.
Note:
The unit can be powered using either the DC power input or PoE (Power over Ethernet).
If powering the unit using DC power, connect the power supply to the power connector at the rear of
the unit.
If powering the unit using PoE, connect a PoE network cable.

Access the video stream

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup
Page 7