Bestway AquaScan Manual Del Propietário página 2

NO. Description
1 Battery cover
2
Battery holder
3
4
On "I"/Off "O" button
5
Adjustable pole
Pole lock
6
Impeller
7
8
Water vent
9
Suction head
10
Note: Drawings for illustrations purpose only. May not
reflect the actual product. Not to scale.
Set Up of Vacuum Product
Brush Assembly
Align the curvature of brush with the suction head and
insert the brush into it securely (Fig.1).
Fig.1
Suction Head Assembly
Carefully discard the cardboard wrap around the impeller.
Don't try to pull the wrap away directly, but cut and unroll it.
Any damage on impeller may cause it to function improperly.
Screw the suction head securely to the threaded connector as
shown (Fig.2).
Battery Assembly
Unscrew the battery cover and take out
the battery holder.
Place 8 AA batteries into the battery
holder according to the polarity marked
on it.
Align the rib and slide the battery holder
into the compartment with the word "TOP"
facing outwards as shown (Fig.3).
Screw the battery cover on tight and
make sure it is secure (avoid stripping the
screw).
Fig.3
CAUTION: Do not press the button to turn
the product on until the cleaner is
submerged in the water and water level is
above the water vent.
Cleaning Your Pool or Spa
Place the product into water and make sure water level is above
the water vent. You can adjust the product length by unscrewing
the pole lock to release the top pole and then extend it to the
desired length according to your pool or spa size. Secure by
tightening the pole lock. Press the "I" marking on the button to start
vacuuming.
CAUTION: Never submerge the handle in
water. During operation, avoid water contact
with the handle and button. Never use the
product without filter basket in place. This can
Handle
Brush
Fig.2
cause permanent damage to the product
impeller and motor.
Cleaning the Pre-filter Bag
WARNING! Turn off the product before
proceeding following steps.
NOTE: Water will be stored inside the
transparent tube and the pole after use. To
remove the water, lift the product from the
pool or spa with the nozzle facing down to
allow the water to drain out.
1. Pull the edge (on back side) of cover to lift its tab (inside) from
the notch on the body, and then pull it down to completely
release the cover (Fig.4).
2. Pull out the pre-filter bag. Empty this bag by removing the
leaves and other debris, and then rinse it. Rinse the cover and
make sure its suction hole is not clogged (Fig.5).
3. Reverse the previous steps to assemble the pre-filter bag back
to the cover and then the cover to the body. Make sure the tabs
on cover inside (2 sides) are secured in the notch of the body
before next operation (Fig.6).
Fig.4
Fig.4
Fig.5
Fig.6
Fig.6
Maintenance and Storage
WARNING! Turn off the product before
any maintenance.
• Always check if the pre-filter bag is full
of debris. Clean if necessary.
• Always check if the suction nozzle is
clogged. Turn off the power
and clean it out.
2