Excluding The Zones; Excluding The Zones From The Front Panel; Excluding The Zones From The Electronic Key - Hiltron l'originale PROTEC5X Manual Para El Usuario

4.3

Excluding the zones

It is possible to exclude the zones that we don't want to be protected during the system
enabling.
For example, during the night hours we can exclude the zone of the volumetric detectors
and leave included the zone with the perimetral protection (access doors, windows) in the way
to move inside of the protected area.
4.3.1

Excluding the zones from the front panel

On system disabled, press the button relative to the zone that we want to exclude during
the system enabling.
The zone relative LED turns on with short flashes.
NOTE: if the zone is opened and the relative LED is on, at the exclusion of the zone the
LED turns off with short flashes.
4.3.2

Excluding the zones from the electronic key

At the moment of the system enabling, it is possible to disable the zones 1 and 2 directly
from the electronic key:
Insert the key in the connector and leave it in.
The LEDs on the connector will turn on following the order shown in the table below:
GREEN RED
LED LED
Extract the key when the desided condition is verified.
CONDITION
Zone 1 excluded
Zone 2 excluded
Zones 1 and 2 excluded
None zone excluded
GREEN LED
Operating
RED LED
SKI/NL
(Additional
connector)
45