Stanley, Multi-Code, Linear, Moore-O-Matic - Clicker CLT 1 Guia De Inicio Rapido

SECTION II
• Determine specific brand and circle above.
• Set brand mode switches on clicker remote.
Step 1
STANLEY
MULTI-CODE
LINEAR/MOORE-O-MATIC
Step 2
Existing
Remote
➡
Match
existing
codes.
Set extra
switches off.
SECTION III
• Open existing remote; determine if there are 9 or 12 code switch settings.
• Set brand mode switches on clicker remote.
• Program clicker remote push button.
Step 1
GENIE 9 SWITCH
GENIE 12 SWITCH
Step 2
Existing
Remote
➡
Match
existing
codes.
Set extra
switches off.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play
with remote control transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. Never permit anyone to cross
path of moving gate or door.
NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this receiver and/or transmitter are
prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
TECHNICAL SUPPORT: 800-442-1255 (MONDAY-FRIDAY 6AM-7PM CST; SATURDAY 8AM-6PM)
Chamberlain, LiftMaster and Moore-O-Matic are Trademarks of Chamberlain Group. Genie is a Trademark of Overhead Door
Corporation. Linear and Multi-Code are Trademarks of Linear Corporation. Master Mechanic is a Trademark of TruServ.
Sears is a Trademark of Sears & Roebuck. Stanley is a Trademark of The Stanley Works.
DoIt is a trademark of DoIt Best Corporation.
114A2504

- Stanley, Multi-Code, Linear, Moore-O-Matic

OFF OFF OFF OFF
ON OFF OFF OFF
OFF ON OFF OFF
Step 3
Clicker
Remote
Step 4
➡
Step 5
Step 6
- Genie - 9 Code Switch, Genie - 12 Code Switch
OFF OFF ON OFF
ON OFF ON OFF
Step 3
Clicker
Remote
Step 4
➡
Step 5
Step 6
WARNING
CAUTION
©2001, Clicker Corporation
All Rights Reserved
• Open existing remote to expose code switches.
• Program clicker remote push button.
➡
- Press and hold both
buttons for 5 seconds
or until LED begins to
flash.
- When LED flashes,
release both buttons.
- Press the button you wish to operate the
opener (your choice).
- Programming is complete, to test, press the
button selected to activate garage door.
➡
- Press and hold
both buttons for 5
seconds or until LED
begins to flash.
- When LED flashes,
release both buttons.
- Press the button you wish to operate the
opener (your choice).
-
Programming is complete, to test, press the
button selected to activate garage door.
Printed in Mexico