Publicidad
Idiomas disponibles
Idiomas disponibles
WHITE OEM input Lock
This is the lock-in cable, which is the Armed cable. This cable looks for a signal when the doors are
locked with the factory remotes. This can be connected to the door actuator cable lock the driver's
door
PINK OEM input unlock
This is the release input cable, the cable is Disarm, searching for a signal when the doors (or
driver's door) are unlocked with the factory remote. There are many factory systems that unlocks
only the driver's door first (called smart unlock). In these systems it is important to find a signal
unlock the driver's door when unlock button on the control when it is pressed for the first time. This
means that you must first find the signal cable that comes only unlock the driver's door.
WHITE/GREEN OEM input VALIDATE
This cable is the Validation. This cable monitors the signal thus providing a high level of protection
for the arming. If the blocking signal is activated by the button door lock means that the system is
not arming. This should tie the switch wire door lock
BLUE/ WHITE OEM input VALIDATE
This cable is the Validation. This cable unarmed monitors the signal thus providing a high level of
protection of disarming. If the enable signal is activated by the release button means that the door
is not dismantling the system. This should tie the switch cable unlocking the door
Mode A:
This mode uses up to 4 cables for locking the vehicle, to determine the state of the system. The
wires (PINK WHITE for lock and unlocking are connected to the driver's door). When the doors are
locked with factory original transmitter, the system will arm. When the doors are unlocked with
factory original transmitter, the system is disarmed. There is a PIN, white with 7 cables (ORANGE
wire is for the lights) one white with 6 pin cable (Cable GREEN / WHITE for flashing lights) must be
connected to each of the two wires in some car models (1. cable parking lights, the turn signals
2nd cart button). And in some car models, the system will need these two wires (1. cord parking
lights, 2. cord directional lights) to cooperate with the WHITE wire (for blocking) and PINK (to
unlock), so that the system is armed or disarmed.
For example:
In some car models, when you press the factory original transmitter, parking light flashes to
indicate that the car has been locked. But when you press the emergency light, the light start
flashes, that causes the system is armed. To avoid this situation, the power indicator lights (Green
/ White) must be connected to the flashing lights. The system recognizes the emergency light when
activated by the flashing lights, not a factory transmitter. The system will not be armed when you
press the button the car flashing lights
10
Genius Car Alarm
Genius Car Alarms
www.alarmasgenius.com
www.geniuscaralarm.com
.
.
23
Publicidad
