Remote Control Installation; Remote Control Transceiver Pcb Installation; Remote Control Activation - Bosch Thermotechnik 7 709 003 736 Instrucciones De Instalación

Remote control installation

4 Remote control installation

4.1 Remote control transceiver PCB installation

WARNING: Electrical discharge!
▶ For safety reasons, disconnect the
power supply to the water heater before
performing installation.
Pre-installation preparation
▶ Loosen the two Philips head screws located on bottom rear
of cover.
▶ Lift front cover upward and remove.
▶ Remove the three screws from the control unit (Fig. 2 ,
[pos.1]).
Fig. 2
▶ Remove the 6 screws from the back cover of the control
unit, to access the electronic board (PCB) (Fig. 3 , [pos.2]).
Fig. 3
10
Remote control transceiver PCB installation
▶ Place the remote control PCB in the back cover of the
control unit as shown in Fig. 4.
Fig. 4
▶ Connect the supplied cable between the main PCB and the
remote control PCB as shown in Fig. 5 .
6720608920-38.1Av
Fig. 5
▶ Reassemble all parts in the reverse order.
6720606990-10.1AL

4.2 Remote control activation

Before the remote control will work, it must
be activated using the procedure described
below with the operator standing in front of
the appliance.
6 720 680 078 (2014/06)