Install Ductwork; Prepare The Hood - KENMORE ELITE 233.51353 Manual De Uso Y Cuidado / Instalacion

1. Determine whether hood will discharge vertically (3¼" x 10"
or 7" Round) or horizontally (3¼" x 10" only).
2. Run ductwork between the hood location and a roof cap
or wall cap.
3. Choose a straight, short duct run to allow the hood to
perform most effi ciently. Long duct runs, elbows and
transitions will reduce the performance of the hood. Use
as few of them as possible. When possible, use at least
2 foot straight runs before any turns. Larger ductwork may
be required for best performance with longer duct runs.
4. Install wall cap or roof cap (sold separately). Connect
metal ductwork to cap and work back towards the hood
location. Use 2" metal foil duct tape to seal the joints
between ductwork sections.
1. If present, remove all protective polyfi lm from the hood
and/or parts. Using the fi nger cup, remove the Hybrid
Filters from the hood by pushing down and tilting fi lters
out.
2. Remove both fi llers by removing the 3 screws holding each
one of them. Slide each one towards the center of the
hood and tilt it up to remove it completely. Set the fi llers
and screws aside.
INSTALL DUCTWORK (DUCTED INSTALLATION ONLY)

PREPARE THE HOOD

R
OOF CAP
S
OFFIT
C
ABINET
H
OOD
18" - 30"
MIN MAX
ABOVE COOKING SURFACE
NOTE: Distances over 30" are at the installer and user
discretion.
B
C
7
3¼" 10"
X OR
7"
ROUND DUCT
(F
OR VERTICAL
)
DISCHARGE
H
OUSE WIRING
(T )
OP OR BACK OF HOOD
W
ALL CAP
3¼" 10"
X DUCT
(F
OR HORIZONTAL DISCHARGE
)