Watts Industries BT DRF-01 Guía De Usuario página 14

on the final position (On the wall or table...), then
put the thermostat in Comfort mode (setting
temperature position 37°C). Close the door and go
to the receiver to check if the new status of the
thermostat has received. (The heating is generally
showed by a Red LED).
- Now return to the thermostat and switch off it.
Check on the receiver again if it's also switched off
(The red LED must be turned off)
o
If the RF signals were received correctly,
adjust your setting temperature as you want.
If the RF signals weren't received correctly,
o
check the installation (Receiver position,
distance...)
* To make the installation easier it will be better to
have the thermostat near to the receiver during the
configuration mode. (A minimal distance of >
1meter must be respected)
14