Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with these tools.
We recommend the following
Filter–Lubricator–Regulator Unit:
USA – No. 16LUB16
Attach the lubricator as close to the tool as practical.
After each two or three hours of operation and at the
beginning of each work shift, if an air line lubricator is
not used, disconnect the air hose and pour about 3 cc of
oil into the air inlet of the tool.
Before storing the tool or if the tool is to be idle for a
period exceeding twenty–four hours, pour about 3 cc
of oil into the air inlet and operate the tool for 5 seconds
to coat the internal parts with oil.
INSTALLATION
Air Supply and Connections
Always use clean, dry air. Dust, corrosive fumes and/or
excessive moisture can ruin the motor of an air tool. An air
line filter can greatly increase the life of an air tool. The
filter removes dust and moisture.
Make sure all hoses and fittings are the correct size and are
tightly secured. See diagram below for a typical piping
arrangement.
The tool is shipped from the factory with a standard 3/4
NPT male inlet thread.
PLACING TOOL IN SERVICE
(Dwg. TPD1518)
OPERATION
Accessory Installation
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool or before performing any
maintenance on this tool. Failure to do so could result
in injury.
For Screw–on type Retainer No. DT9–22:
1. Grasp the Retainer and unscrew from the Barrel.
2.
Insert the accessory through the Retainer Assembly and
install it on the tool. Screw the Retainer onto the barrel
until you feel the Retainer O–ring drop into the groove in
the Retainer.
For Hitch Cutter Type Retainer No. DT9–273:
1.
Retract Guard to reveal accessory hole in
Retainer (67).
2.
Grasp the Retainer and unscrew from the Barrel.
3.
Insert the shank portion of the accessory through the
cutout in the side of the Hitchcutter. Screw the Retainer
onto the Barrel until you feel the Retainer O–ring drop
into the groove in the Retainer.
For Latch Type Retainer No. DT9–240 and DT9–340:
1.
Operate the Latch until it is 90 degrees to the body of the
tool and clicks into position.
2.
Insert the accessory into the tool until the collar of the
accessory is past the Latch.
3.
Operate the Latch until it is parallel to the tool and it
clicks into position.
OPERATING THE TOOL
1.
Hold the Handle (and front of tool if working horizontally)
and press the point of the chisel firmly into the workpiece.
2.
Use a steady and well–balanced stance and squeeze the
Trigger.
3.
Power is increased by depressing the Trigger.
4.
Experience will indicate the correct amount of pressure to
the tool. Normally, the amount of pressure is correct when
the tool hits rhythmically, is comfortable to hold and
works efficiently.
3
Publicidad
Tabla de contenido
