Installation Explanations - Glaziar Predator S40 Manual De Instrucciones

9. Drainage
Internal Tank Water Full Alarm Function
The inner water tank in the air-conditioner has one water level safety switches, it controls
water level. When water level reaches an anticipated height, the water full indicator lamp
lights up. (If water pump is damaged, when the water is full, please remove the rubber
blockage at the bottom of unit, and all water will drain outside.)
CONTINUOUS DRAINGE
– When you plan to leave this unit unused for a long time, please remove the rubber
blockage from the drainage hole at the bottom of unit, and connect a drain hose to the
lower fixing clip. All the water in the water tank will drain outside.
– You can drain the water as the above when the unit working at the HEAT mode.
– If water pump is damaged, continuous drainage can be used, and under this condition,
the water pump is not activated. The unit can also work well.
– If water pump is damaged, intermittent drainage can also be used. Under this condi-
tion, when the water full indicator lamp lights up, please connect a drain hose to the
lower fixing clip, then all the water in the water tank will drain outside. The unit can also
work well.

7. Installation Explanations

1. Installation Explanations:
– A removal air-conditioner shall be installed in the flat and empty place all around. Don't
block the air outlet, and the required distance around should be at least 30cm. (See
Fig.8)
– Should not be installed in wet location, such as the laundry room.
Socket wiring should be in accordance with the local electric safety requirements.
Fig. 8
46