Uebler P22-S Manual De Uso Y Montaje página 15

24 23 2 37
36
A
3. If necessary, unlock the twist grip (24) with the key (36).
4. Screw open the clamp (23) with the twist grip (24), until the
clamp (23) is about a hand's width apart (A).
5. Press the clamp (23) together and hold.
The clamp (37) opens.
6. Attach the bracket (2) in a suitable position for placing the rack
frame on (7) and release the clamp (23). The clamp (37) closes.
24
2
36
23
25
21
22
Attention
Only attach the bracket (2) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
7. Position the bracket (2) on the bicycle frame and screw
the clamp (23) tight with the twist grip (24).
8. Lock the bracket (2) with the key (36) and remove the key (36).
9. Pass the lashing strap (21) between two wheel spokes,
thread into the buckles (22) and tighten firmly by hand.
10. Retighten the lashing straps (21) using the tensioning
lever (25) (arrow).
Attention
Do not tighten the lashing straps (21) too firmly, otherwise the
7
lashing straps (21) and/or the tyres/rims could be damaged.
Tightening the lashing straps (21) places these under tension.
To loosen this tension, the catch (20) may need to be
pressed firmly.
Mounting the second bicycle
M+P-25A-0143
2
The second bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
Attention
Only attach the bracket (3) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
The second bicycle is attached using the long bracket (3).
M+P-25A-0144
- 13 -
3
M+P-25A-0156