Getting Started - CAPITAL SPORTS OUTRUN 2XC Manual Del Usuario

EN
38

GETTING STARTED

Note: Check the voltage on the equipment label before use. Only connect
the device to sockets that correspond to the voltage of the device.
E_1 Electrical connection
E_2 On (I) and Off (0)
E_3 Overload protection
Power On
1. Attach the power cable to the E_1 power connection and into the plug in
the socket.
2. Set the switch E_2 to position (I).
Power Off
1. Set switch E_2 to position (0).
2. Disconnect the plug from the socket and remove the mains cable from the
E_1 power supply.
Note: When the current generated by the treadmill exceeds the specified
threshold, the overload protector E_3 will automatically be disconnected
to protect the controller and the motor. Press the overload protector again
for normal use.