A.
B.
C.
D.
E.
F.
G.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVDs and staples
Will not shred: Adhesive labels, continous form paper, transparencies, newspaper,
cardboard, laminates, paper clips, file folders, X-rays or plastic other than noted above
Paper shred size:
Micro-Cut .................................................................... 5/64 in. x 5/16 in. (2mm x 8mm)
Card/CD shred size:
Strip-Cut ....................................................................................................5/16 in. (8mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
2
H.
KEY
A. SafeSense
Technology
®
B. CD/card entry
I.
C. See safety instructions
D. Paper entry
E. Pull-out bin
F. Window
G. Casters
H. ON/OFF switch
1. OFF
2. ON
Maximum:
Sheets per pass ............................................................................................................. 7*
Cards/CDs per pass ....................................................................................................... 1*
Paper entry width .............................................................................8-13/16 in. (224mm)
Cards/CDs width ...................................................................................4-7/8 in. (124mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V, 60 Hz, 4.5Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Maximum recommended daily usage rates:
300 sheets per day; 25 credit cards; 10 CDs.
Fellowes SafeSense
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
) to back out object.
I. Control Panel and LEDs
1. Overheat (red)
2. SafeSense
indicator (yellow)
®
3. ON/OFF (blue)
4. Reverse
5. Forward
7 sheets per pass to avoid jams.
®
shredders are designed to be operated in home and office environments ranging
operate shredder. In case of emergency, move switch to OFF (O) position. This
action will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
ENGLISH
Model 450Ms
(I) position to