Installing The Canopy Housing; Assembling The Trim Cover - Rejuvenation The Falcon Manual Del Propietário

NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed (Figure 1a).
2. Securely attach and tighten the canopy screw
cover over the shoulder screws in the hanger
bracket utilizing the keyslot twist-lock feature
(Figure 1b).
1. Position the trim cover onto the blade plate
bottom using #6-32 screws. (Figure 1)

Installing the Canopy Housing

Assembling the Trim Cover

Blade Plate
Trim Cover
HARDWARE USED:
#6-32
SCREWS
10
Figure 1a
Figure 1b
#6-32
Pan Head Screw
w/Lock Washer
Figure 1
x 3
Blade