How To Assemble Your Ceiling Fan - Rejuvenation The Falcon Manual Del Propietário

1. Prior to assembly, set aside and save the hardware
bags packed in the packing. Remove the hanger ball
by loosening the setscrew in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 6. (Figure1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. The fan comes with black and white wires.
Separate and untwist the two wires route them through
the downrod. Loosen the two setscrews in the downrod
support. Install downdrod into coupler. Align the clevis
pin holes in the downrod with the holes in the downrod
support. (Figure 3)
4. Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 4)
WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.

How to Assemble Your Ceiling Fan

Hanger
Ball
Hairpin
Clip
Black and White wires
Hairpin
Clip
6
Pin
Setscrew
Figure 1
Clevis Pin
Figure 2
Downrod Support
Figure 3
Set Screw
w/Hex Nut
Figure 4