Solar PI1500X Manual Del Usuario página 10

TROUBLESHOOTING
Problem:
Answer:
Answer:
Problem:
Answer:
Answer:
Answer:
Low or no output voltage from the power inverter
Check connections between the 12 Volt power source and
the power inverter as detailed in Connecting Your Power
Inverter.
Using the incorrect type of voltmeter to test the output
voltage. To accurately measure the the output voltage of
your SOLAR Power Inverter, use only a voltmeter identified
as a "True RMS" reading voltmeter.
Red LED ON
The voltage of the 12 Volt power source may have dropped
below 9.5 Volts – check 12 Volt power source voltage and
recharge as needed.
The device being powered is placing a power demand on the
inverter that is beyond its operating capacity – use a higher
capacity power inverter or cease powering that device using
your power inverter.
The inverter is too hot – allow the inverter to cool. Check for
adequate ventilation. If problem persists, reduce the the load
on the power inverter to the rated continuous power.