Legal Notice - Promax RM-010 Manual

RM-010 Remote control for PROMAX-10 / 8+ / 8
Once the PC and the PROMAX-10/8+/8 are connected through the CC-208 cable,
turn on both equipments and then run the RM-010 software.
If a Communication error message appears:
1.- Verify the PROMAX-10/8+/8 is on.
2.- Check the connection between the PROMAX-10/8+/8 and the PC.
3.- Verify the selected communication port. To do this select the Config menu in
the main bar and click on Communication Port (COM 2 by default).
If your PROMAX-10/8+/8 has a software version previous (2.30 PROMAX-10,
1.12 PROMAX-8+ or 1.41 PROMAX-8) it will be necessary to upgrade it to
the new version before carrying out any other operation. Previous control
softwares may not be 100% compatible with RM-010. The updating process
lasts for 30 minutes approximately. Before starting the upgrade it is important
to verify that the PROMAX-10/8+/8 battery is fully charged and the PROMAX-
10/8+/8 is not in auto-power off mode, in order it does not turn off during the
updating process. Never disconnect the Cable TV analyser from the serial
port before exit completely the RM-010 program.
Under no circumstances PROMAX ELECTRONICA, S.A. is liable for data
loss or any damages that may be caused directly or indirectly by this program.
Although we have done our outmost to develop a program that is both useful
and reliable, it is understood that the use of the program and of the data and
information that are generated with it are the sole responsibility of the user.
12/2002
VERY IMPORTANT REMARK

LEGAL NOTICE

Page 3