Black and Decker Price Pfister Brookwood 34 Serie Manual Del Usuario página 4

11
11A
11B
11D
11C
11 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (11A) through Hose Guide (11B).
From underneath sink, push Quick Connect Housing (11C), located on the end of the Spray
Hose (11A), firmly upward onto the receiving Tube (11D), until unable to push any further.
Pull down on the quick connect housing (11C). If the housing and the Inner Collet (11E)
separate slightly, but do not pull off the receiving Tube (11D), quick connect is secure.
12
12A
12D
12B
12C
HOT
12 WATER SUPPLY LINES
Gently separate hot and cold supply tubes (12A), approximately three inches apart.
Connect water Supply Lines (12C) to Faucet Inlets (12B). Hot water supply line goes
to hot inlet fitting indicated by red tag (12D). (Supply lines not included). Follow
manufacturer's instructions when installing supply lines. Do not twist supply tubes (12A)!
13
13 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
Note: After installation is complete, flush faucet (see step 16).
11A
11E
11D
11C
11C
12A
12B
12C
COLD
ENGLISH
14
11B
14B
14 FAUCET FUNCTION
By lifting the Lever Handle (14A) up, the valve will be activated allowing water to flow.
The water flow will increase by continuing to lift up the Lever Handle (14A). By rotating
the Lever Handle counter-clockwise, the water temperature will decrease to cold flow
only. By rotating the Lever Handle clockwise, the water temperature will increased to
hot flow only.
The Spout (14B) can be rotated around the Faucet Body in any direction.
15
15 SIDE SPRAY OPERATION
The Side Spray (15A) can be pulled forward to spray water in any direction. To activate the
Side Spray, press the Toggle Button (15B) located on the back of the Side Spray (15A).
16
16 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (16A). Turn Valve (16B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (16A) by
separating the Aerator Shell (16C), Basket (16D), and Washer (16E). Once parts have
been cleaned, reassemble by reversing steps.
4
FAUCET FUNCTIONS
ON
HOT
COLD
15B
15A
16E
16D
16A
16C
14A
14A
16B