Jung FMAS26UP Instrucciones De Servicio página 8

Actuador pulsador/de conmutación eNet 2 fases mini
Run-on time
Manual switch-off of the run-
on time
Operating hours
Extended channel settings
Parameters
Operating mode
Manual commissioning
Local Operation
Behaviour on voltage return
82579133
J0082579133
0 s ... 24 h
Basic setting: 0 s
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
Setting options, Basic set­
ting
Switching operation
Push-button operation
Flashing
Continuous on
Continuous off
Basic setting: Switching ope-
ration
On, Off
Basic setting: On
On, Off
Basic setting: On
On
Off
Last value
Configured brightness
Basic setting: Off
8/11
As soon as a run-on time has
been entered, the actuator will
no longer remain on perma-
nently, but only for the length
of the run-on time. The run-on
time is restarted if actuation is
repeated. This parameter is di-
rectly connected to the "Ma-
nual switch-off of run-on time"
parameter.
Comment: The set times apply
to operation using radio trans-
mitters. The relay is switched
immediately when the Prog
button is pressed.
Allows manual switch-off of a
running run-on time. If the pa-
rameter is switched off, then a
switch-off command will also
switch the actuator on. This
parameter is directly connec-
ted to the "Run-on time" para-
meter.
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the meter to "0". The de-
vice must be programmed to
apply the change.
Explanations
See Device and channels.
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can-
not be reset to the factory set-
ting.
Blocks the output for operation
using the Prog button.
Defines the behaviour of the
output after voltage return.
24.03.2017