Service Information - Black+Decker BDPH200 Manual De Instrucciones

Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical
products from the household, at municipal waste
sites or by the retailer when you purchase a new
product.
TROUBLE! MATERIAL RUNS OR DRIPS.
WHAT'S WRONG?
Spraying too much material.
Spraying too slowly.
Spraying too close.
Viscosity too thin.
TROUBLE! TOO MUCH OVER SPRAY.
WHAT'S WRONG?
Sprayer too far from surface.
Too much material being sprayed.
TROUBLE! LITTLE OR NO MATERIAL BEING RELEASED.
WHAT'S WRONG?
Check valve ball stuck.
Spray nozzle/tip clogged.
Pickup tube loose or clogged.
Material adjustment knob setting too low.
Air inlet blocked.
Material too thick.
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING.
WHAT'S WRONG?
Viscosity of material is too high.
TROUBLE! SPRAYER PULSATES.
WHAT'S WRONG?
Air filter clogged.
Material in canister almost empty.
TROUBLE! LIQUID COMES OUT SIDE OF CANISTER.
WHAT'S WRONG?
Lid not on square or tight enough.
Paint on threads of canister and lid.

SERVICE INFORMATION

BLACK+DECKER offers a full network of company-owned
and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool
service. For more information about our authorized service
centers and if you need technical advice, repair, or genuine
factory replacement parts, contact the BLACK+DECKER
location nearest you, or visit us at
www.BlackandDecker-la.com
TROUBLESHOOTING
WHAT TO DO...
Reduce air flow by turning material adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
WHAT TO DO...
Reduce distance to surface.
Reduce air flow by turning material adjustment knob.
WHAT TO DO...
Remove check valve. Depress ball to loosen. Add lubricant Figure Q.
Clean nozzles.
Check tube.
Increase setting
Clean or change air filter.
Check viscosity recommendation
WHAT TO DO...
Thin material per manufacturer recommendation.
WHAT TO DO...
Clean or change filter.
Refill canister.
WHAT TO DO...
Remove lid and reattach squarely and evenly, then tighten lid securely.
Clean threads on top and sides of canister and lid.
ENGLISH • 25