Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Overview
The default password for the WELL COM is 2323.
Setting Up Products with WELL COM
The WELL COM is ready to use straight out of the box.
To configure your products with WELL COM you must perform the following steps:
1.
Connect WELL COM to power.
2.
Turn on Wi-Fi™ on your mobile device.
If you have not already done so, download and install the WELL COM app onto your mobile device.
3.
Go to the Wi-Fi™ settings on your mobile device and connect to WELL COM's default Wi-Fi™ (SSID) WIFI-
WELL COM. To avoid interference with other wireless signals in the immediate area, manually select the Wi-
Fi™ channel (CH 2 or CH11) on the WELL COM within the app settings.
4.
Set your products to receive signal input from WELL COM. For details, refer to the User Manuals for the
products in your setup.
a.
Set products to receive signals on the same channel as was set on WELL COM in the previous step.
b.
Set products to their most basic DMX personality.
Make sure the DMX starting address is set to 001.
5.
Select whether WELL COM receives signals wirelessly or via a DMX cable.
For DMX products, be sure to use a DMX cable to connect from DMX Out of the product transmitting the
DMX signal to the DMX In of the product receiving the DMX signal. An adapter has been included for this
purpose.
6.
Once your products are properly connected to WELL COM, and WELL COM is properly connected to the WELL
COM app, open the WELL COM app on your mobile device.
WELL COM QRG Rev. 2
QUICK REFERENCE GUIDE
1
#
Description
1
<LINK>
2
DMX
3
Power Charger
4
Wi-fi Pairing
5
DMX Signal
6
Wi-fi Signal
7
Battery Life
8
<PWR>
2
3
4 5 6
Function
Press to reset wireless fixture pairing
DMX in port (adapter included)
Micro USB B port for charging the battery
•
External power supply included
•
Battery Charge Time - 8 hours
•
Battery Life - 8 hours
Blinks for 5 seconds after pressing <LINK>, and
then intermittently while connected to products
Blinking - No DMX signal detected
Solid - DMX signal detected
Blinking - No Wi-Fi signal detected
Solid - Wi-Fi signal detected
Green - Power is currently 50–100%
Orange - Power is currently 25–50%
Red - Power is currently less than 20%
Blinking - Battery is charging
Press to power on/off the device
7
8
EN
2
Publicidad
Tabla de contenido
