Slippage Check; Feeding In The Wire; Risk Of Injury - Abicor Binzel MF3-Laser Front/Rear Instructivo De Servicio

MF3-Laser Front/Rear

6.3.4 Slippage check

Position the wire protruding from the feeding body approx. 50 mm above of a suitable object at an exit angle of approx.
45 degrees.
 Fig. 15 Slippage check on page EN-17
Feed the wire against this resistance and check if slippage occurs.
If slippage occurs, the contact pressure must be increased.
1 Feeding body
Fig. 15 Slippage check

6.4 Feeding in the wire

CAUTION

Risk of injury

Physical injury caused by the start of the wire.
• Keep the process-side drive away from the body.
1 Open the housing cover.
 Fig. 9 Opening the housing cover on page EN-13
2 Swivel out the rocker arm.
 Fig. 10 Swivel open the rocker arm on page EN-14
BAL.0511.0 • 2019-06-13
3
2 Wire protruding from feeding body
6 Commissioning
1
2
3 Wire
EN - 17