Mounting Tool For Encoder Reel - Abicor Binzel MF3-Laser Front/Rear Instructivo De Servicio

MF3-Laser Front/Rear

6.4.1 Mounting tool for encoder reel

When replacing the encoder reel, it must be re-tightened.
NOTICE
• A socket wrench (SW10) is required to tighten the encoder reel (2).
1
3
1 Bracket
2 Encoder reel
Fig. 18 Encoder reel
1 Push the bracket (1) backwards.
2 Position the mounting tool (3) at a slight angle and push it under the encoder reel (2).
3 Use a socket wrench to tighten the encoder reel (2) (max. tightening torque 1 Nm).
BAL.0511.0 • 2019-06-13
3 Mounting tool
6 Commissioning
2
EN - 19