Publicidad
Idiomas disponibles
Idiomas disponibles
7. Sampletype menu
(not for all tests)
Touch Serum or Blood and
confirm the selection with
Viewing and processing the test results
The Eurolyser laboratory photometer can store up to 250 patient and control results in its memory. Once
capacity is exceeded, oldest results are deleted.
The following parameters are saved from each test:
1. Single result menu
The result is shown. Touch
print it out. Touch
export it to an HIS/LIS or PC, or
touch
to display the
photometric data. Touch
close the menu and end the test.
0453172b-2413-4271-9898-33b9292ff0b1 / DP1.0
8. Hematocrit menu
(not for all tests and/or sampletypes)
Enter the hematocrit value and
.
confirm it with
Be sure to handle the test cartridge according the instructions on the
package insert as well as make sure the test cartridge is firmly capped
before you insert it into the smart laboratory photometer.
Be sure the test cartridge is completely put into the proper opening in the
smart laboratory photometer.
Use only test cartridges that are approved by the manufacturer. Otherwise
severe damage to the smart laboratory photometer and/or incorrect results
can occur.
Do not attempt to open or close the door manually.
2. Remove cartridge menu
to
The smart laboratory photometer
to
automatically opens the door.
Remove the test cartridge and
discard it. Touch
to
door. The main menu now
appears. Touch
overall result menu.
9. Start analysis menu
.
3. Overall result menu
to close the
to go to the
8 / 12
Insert the test cartridge.
Touch
: The door closes and
the smart laboratory photometer
runs the test automatically.
Use
and
to scroll back
and forth within the results. Touch
to print the result(s). Touch
to transmit the result(s) to
a PC. Touch
to delete the
result(s). Touch
to return to
the main menu.
Eurolyser Diagnostica GmbH
Publicidad
