Acuity Brands JUNO T283L Instrucciones De Instalación

WARNING: For your safety, read and understand instructions completely before starting installation.
Note: Use with non-Juno fixtures voids Juno warranty.
SAVE THESE INSTRUCTIONS
Installation Instructions for T283L/T285L Accessories
Step 1. Remove all items from accessory packaging.
Step 2. 3 set screws are required for installation. Place up to 2 accessory
media in between the fixture and accessory holder, snoot, or barn door.
(See T285/T283 spec sheet for compatible accessory media).
Step 3. Line up the accessory holder, snoot, or barn door so that the set screws
will fasten to the fixture bezel.
Step 4. Use the provided Allen wrench to tighten all 3 set screws until you
cannot pull off the accessory. Caution: Do not over-tighten, however pull
lightly on the accessory to make sure it is snug, and will not come off the
fixture.
Note: Lining up the accessory holders to the fixture bezel is important due to
when the set screws are installed and tightened, they will leave a mark.
Figure 1. Extrenal Accessory Holder:
T770BL, T770SL, T770WH
Figure 2. External Snoot/Accessory Holder:
T5788BL
Figure 3. External Barn Door/Accessory Holder:
T5774BL*
* Cannot be used with T579BL, Cube Cell louver
WARRANTY
5-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Technical Services Phone (888) 387-2212
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
Rev 10/17 P4218
Figure 1
Figure 2
Figure 3
1 of 1