Installation Procedures - Asus Silent Square Guia De Inicio Rapido

? Before you proceed
Take note of the following precautions before you install the Silent Square CPU Cooler.
1.Make sure to turn off your computer and unplug the cable from the power source before
installing CPU Cooler.
2.Install the CPU before you install the CPU Cooler.
3.Remove the chassis fan or the air duct on the chassis side panel to clear the air path, if necessary.
4.Remove default retention socket on the motherboard, if there is any, before install the CPU cooler.

? Installation Procedures

1. Remove the sticker from theuniversal back plate.
Aim for the 4 apertures, and position the back plate
underneath the motherboard.(Note: Please skip this
step if there is already a back plate underneath the
motherboard.)
Apply an adequate layer of the thermal grease onto
2.
the surface of the installed CPU.
1
3
-2-
3.
Assemble the universal retention bracket: Insert the
Stand-offs into the screw holes of retention Bracket.
?P4 478/775 processor: use four P4 screws and stand-offs, as
shown in figure 4
?K8 processor: use two K8 screws and stand-offs, as shown in
figure 5.
4. Place the retention bracket on the motherboard.
Fasten the retention module with screws. Use a
screw driver to tighten the screws in a diagonal
sequence until everything is firmly in place.
2
Gently place the cooler on the retention bracket.
5.
Make sure the arrow on the cooler fan bracket going
out from the chassis rear panel, as shown in figure 10.
4
P4 478/775 K8
6
P4 478/775 P4 478/775
8
K8 K8
10
-3-
5
7
9
11