Troubleshooting - Core BH Manual

EN
USER MANUAL

TROUBLESHOOTING

Description
System overcurrent
System overcurrent
TMM sensor
Error in the motor
Error in the motor's
sensor
Low battery
Blocked motor
System overcurrent
Overheating
Protection against
overheating
Communication
error
Pedal error
Error in the speed
sensor
38
Error
Check that the connection between the motor and the
01
controller is OK. If not, replace the controller.
Blinking
02 Replace the controller.
Blinking
Check that the connection between the TMM sensor
and the controller is OK. Check if the TMM sensor's
03
output is exceeding the normal range; it should be 0.1
Blinking
V-3.5 V.
04 Check the motor's connector or the controller.
Blinking
Check that the connection between the motor and
the controller is OK. If the sensor inside the motor is
broken, replace the sensor or the motor with a new
05
one. Check that the connection between the motor's
Blinking
cable and the controller is OK. If not, replace the
controller.
08 Check the battery level or replace it with a new one.
Blinking
09 Motor stopped. Replace motor.
Blinking
If there is faulty contact between the controller and the
10
motor's connector, replace it with a new one.
Blinking
If the temperature exceeds the set value, the current
11
will become gradually weaker.
The controller stops on entering temperature
12
protection mode.
13 Check the cable and the connector.
14 Take your foot off the pedal and turn it back on.
Check the speed sensor and magnet position in the
33
wheel.
Observations
CORE