PUTTING INTO OPERATION
01
06
Attention! Make sure that the appliance is switched off and the power
cord is disconnected.
01
Unpack the appliance and set it up. Open the fragrance/filter compartment
3+7, remove the pre-filter 5+10, the VENTAcel filter 6+11 and fragrance 8
and unpack them.
02
Re-insert the VENTAcel filter 6+11 and pre-filter 5+10.
03
Inserting the fragrance: Twist open the fragrance cap and insert it into the
fragrance holder 9. Insert up to three fragrances into the fragrance holder
4+9.
04
Close the fragrance/filter compartment 3+7.
05
The display 1 can be adjusted to three positions.
06
The power cable can be adjusted to the desired length by winding it up in
the cable compartment 12
Attention! The coupling of the mains cable must be plugged firmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power cord and switch
on the appliance at the on/off switch
2 or with the remote control 13.
7
US
ON/OFF
Set fan stage