Assembly; Fitting And Removing The Battery; Fitting And Removing A Drill Bit Or Screwdriver Bit - Steren HER-153 Manual De Instrucciones

FITTING AND REMOVING THE
BATTERY
To fit the battery, line it up with the
receptacle on the tool. Slide the
battery into the receptacle and push
until the battery snaps into place.
To remove the battery, push the
release button while at the same time
pulling the battery out of the receptacle.

FITTING AND REMOVING A DRILL BIT OR SCREWDRIVER BIT

1.- Lock the tool by setting the forward / reverse slider to the centre position.
2.- Hold the rear part of the chuck.
3.- To open the chuck, turn counterclockwise.
4.- Insert the bit shaft into the chuck.
5.- Firmly tighten the chuck by turning the front part clockwise.

Assembly

9