Assembly Instructions - Gardenline 22096-20 Manual Del Usuario

*Complete assembly by securely tightening all screws after
placing Canopy Supports (E) over pergola frame.
E
E
EE
E
Fig. 11
STEP 7:
Place all five assembled Canopy Supports (E) across the top of the frame
so that they are resting against Crossbeams (C & D). For a consistent
look, place Canopy Supports (E) on the pergola frame so that the
head of bolts used to hold these parts together are all facing in the
same direction. Insert two Bolts M6x65mm (EE) through both ends
of assembled Canopy Supports (E) and into Crossbeams (C & D); see
Figure 11. Finish assembly by tightening all screws left loose through
the construction process.
14
support@tdcusainc.com
MODEL: 22096-20 PRODUCT CODE: 44964

Assembly Instructions

E
E
E
E E
E
E
EE
(10) M6X65 mm Screw
AFTER SALES SUPPORT
USA
04/2020
USA
*Parts G1 and G2 are not stiff when connected. They're meant be
E
Fig. 12
Fig. 13
STEP 8:
Place Canopy (N) over Canopy Supports (E). Pull Canopy (N) between
Canopy Guide Bar (F) and assembled Crossbeams (B) at either end
of pergola frame. Please note that the canopy tags should be facing
inward once this step is complete.
Insert Canopy Weight Bar (G
of Canopy (N); see Figure 12. Insert Canopy Weight Bar (G
opposite side of sleeves found at ends of Canopy (N); see Figure 13.
Insert end of Canopy Weight Bar (G
Bar (G ), so that they lock in place; see Figure 14. Please note that the
1
latches to these two parts should be facing outward.
AFTER SALES SUPPORT
1800 599 8898 1800 599 8898
USA
MODEL: 22096-20 PRODUCT CODE: 44964
flexible, so they have room to give.
G
1
N
N
G
G 2
) through sleeves found at either end
1
) into the end of Canopy Weight
2
04/2020
USA
Assembly Instructions
1
G
2
Fig. 14
EE
(8) M6X65 mm Screw
) through
2
15
support@tdcusainc.com