Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
*Do not tighten screws down completely during
this portion of assembly.
Fig. 8
B
I
I
EE
BB
A
1
STEP 5:
Place assembled Crossbeams (B) on top of two standing Poles (A
For a consistent look, place Crossbeams (B) on Poles (A
head of bolts used to hold these parts together are facing outward;
see Figure 6. Please note that A
right when facing these parts from outside the pergola. Insert two
Bolts M6x65mm (EE) through either end of assembled Crossbeams (B)
and into the tops of Poles (A
1
See Figure 9 for the correct orientation of A
bolt inserts intended for part F are facing in the correct direction.
See Figure 8 for the correct orientation of A
the crossbeams to A
and A
1
Insert Bolt M6x15mm (BB) through Support (I) and into female-bolt
insert beneath assembled Crossbeams (B); see Figure 8. Insert second
Bolt M6x15mm (BB) through opposite ends of both Supports (I) and
into both Poles (A
& A
).
1
2
Repeat these steps to assemble second set of Poles (A
Crossbeams (B).
12
support@tdcusainc.com
MODEL: 22096-21 PRODUCT CODE: 44964
Assembly Instructions
EE
(8) M6X65 mm Screw
BB
Fig. 6
(8) M6X15 mm Screw
Fig. 9
B
I
I
BB
A
2
2X
Fig. 7
& A
) so that the
1
2
will be on your left and A
1
& A
); see Figure 7.
2
so that the female-
2
, before assembly of
1
is complete.
2
& A
1
AFTER SALES SUPPORT
USA
05/2021
USA
EE
(8) M6X65 mm Screw
BB
(8) M6X15 mm Screw
Female-Bolt
Insert
& A
).
1
2
on your
2
Assembled
Crossbeam
C & D
STEP 6:
Insert cutout notch of assembled Crossbeams (C & D) into cutout notch
of Crossbeams (B). Insert two Bolts M6x65mm (EE) through either end of
assembled Crossbeams (C & D) and into the tops of all Poles (A
Figure 10.
Repeat these steps to connect all crossbeams to remaining Poles (A
Insert Bolt M6x15mm (BB) through Support (I) and into female-bolt insert
beneath assembled Crossbeams (C & D). Insert second Bolt M6x15mm
(BB) through opposite ends of Supports (I) and into Poles (A
) with
2
Figure 11.
AFTER SALES SUPPORT
1800 599 8898
1800 599 8898
USA
MODEL: 22096-21 PRODUCT CODE: 44964
*Do not tighten screws down completely during this
portion of assembly.
C
B
D
B
A
1
A
2
EE
B
Fig. 10
Fig. 11
05/2021
USA
Assembly Instructions
D
B
C
B
A
2
A
1
I
BB
& A
); see
1
2
& A
).
1
2
& A
); see
1
2
13
support@tdcusainc.com
Publicidad
Tabla de contenido
