Assembly Instructions - belavi 22096-21 Manual Del Usuario

*Complete assembly by securely tightening all screws after
placing Canopy Supports (E) over pergola frame.
Fig. 12
E
E
EE
E
Fig. 13
STEP 7:
Place all five assembled Canopy Supports (E) across the top of the frame
so that they are resting against Crossbeams (C & D). For a consistent
look, place Canopy Supports (E) on the pergola frame so that the head
of bolts used to hold these parts together are all facing in the same
direction; see Figure 12. Insert two Bolts M6x65mm (EE) through both
ends of assembled Canopy Supports (E) and into Crossbeams (C & D);
see Figure 13.
14
support@tdcusainc.com
MODEL: 22096-21 PRODUCT CODE: 44964

Assembly Instructions

E
E
E
E
E
E
E
EE
(10) M6X65 mm Screw
AFTER SALES SUPPORT
1800 599 8898
USA
05/2021
USA
*Parts G1 and G2 are not stiff when connected, they are meant
G 1
Fig. 14
E
Fig. 15
STEP 8:
Place Canopy (N) over Canopy Supports (E). Please note that the canopy
tags should be facing inward once this step is complete.
Insert Canopy Weight Bar (G
Canopy (N); see Figure 14. Insert Canopy Weight Bar (G
opposite side of sleeve found at ends of Canopy (N); see Figure 15.
Insert end of Canopy Weight Bar (G
Bar (G ), so that they lock in place; see Figure 16. Please note that the
1
latches to these two parts should be facing outward.
AFTER SALES SUPPORT
1800 599 8898
USA
MODEL: 22096-21 PRODUCT CODE: 44964
be flexible.
N
N
G
1
Fig. 16
G
2
) through sleeve found at either end of
1
) into the end of Canopy Weight
2
05/2021
USA
Assembly Instructions
G
2
) through
2
15
support@tdcusainc.com