Frequently Asked Questions (Faqs); Notification; Declaration Of Conformity - Marmitek Surround Anywhere 221 Modo De Empleo

8 Frequently asked questions (FAQs)

The LED remains off after the transmitter / receiver is switched on
Check the power outlet and the power supply.
Check the power supply's voltage.
No audio at receiver side

Check that the blue LED is lit continuously.

Adjust the receiver's volume control.

Does the rear surround speaker have a signal?
Audio is distorted or too low

Adjust the volume control of the surround set until no more clipping
occurs.

Adjust the volume control of the receiver until no more clipping occurs.
Do you have any other questions that have not been resolved by the
above information? Please go to

9 Notification

9.1

Declaration of Conformity

Hereby, Marmitek BV declares that this Surround Anywhere 221™
is in compliance with the essential requirements and other relevant
provisions of the following Directives:
Directive 2014/53/EU of the European Parliament and of the Council of 16
April 2014 on the harmonisation of the laws of the Member States relating to
the making available on the market of radio equipment and repealing
Directive 1999/5/EC.
Directive 2011/65/eu of the European parliament and of the council of 8 June
2011 on the restriction of the use of certain hazardous substances in
electrical and electronic equipment.
Commission Regulation (EC) No 278/2009 of 6 April 2009 implementing
Directive 2005/32/EC of the European Parliament and of the Council with
regard to eco-design requirements for no-load condition electric power
consumption and average active efficiency of external power supplies.
You can read the full Declaration of Conformity at
Surround Anywhere 221™
www.marmitek.com
http://www.marmitek.com
13