Technical Specifications; User Manual - PNI LED 2000 Manual De Usuario

CB Antenna PNI Led 2000

Technical specifications

• Frequency: 26 - 28 MHz
• Power: 100 W (continuous) / 500 W (for short time)
• S.W.R.: ≤ 1.2:1
• Whip length: 750 mm
• Impedance: 50 Ohm
• Connector: PL259
• Temperature: -26°C ~ +60°C
Installation
• Fix the antenna onto a magnetic threaded base (not included) previously
attached to the car dome.
• Connect the PL259 plug on the magnetic base cable to a CB radio.
• Measure the SWR of the antenna in an open area using a reflectometer.
• In some cases, it might be necessary to raise or shorten the whip of the
antenna to get an optimal SWR value. For maximum performance, we
recommend that this procedure, called tuning, be performed by qualified
personnel.
Datasheet 2