Universal Forest Products Slidelock Manual Del Usuario página 5

Using the Slidelock™ bracket with the Veranda Windham Panel
WARNING:
• Improper installation of this product can
result in personal injury. Always wear
safety goggles when cutting, drilling and
assembling the product.
• Incorrect installation may cause harm to
the panel, bracket or individual.
• Not pool code approved.
NOTICE:
• DO NOT attempt to assemble the kit if
parts are missing or damaged.
• DO NOT return the product to the store,
for assistance or replacement parts call:
1-800-336-2383.
Follow Veranda vinyl fence panel
1
instructions to mark dovetail position on
posts (fig. 1).
Vinyl Post
Repeat previous steps for all brackets.
4
Place panel assembly above the dovetails,
and lower the brackets onto the dovetails
until snug (Fig. 4). Dovetails should not be
visible once installed properly.
TOOLS NEEDED:
Vinyl Fence Panels
Vinyl Fence Posts
Safety Glasses
Level
Tape Measure
Drill & Drill Bits
Pencil
Rubber Mallet
Template
Pan Head Screws
2 Place bottom of dovetail at marked point
and attach with three #10 x 1" flat head
screws (fig. 2). Adjust as needed.
Fig. 1
5 Align template to bracket (Fig. 5). Mark
screw hole locations and pre-drill screw
holes using a
and install pan head screws into one side
of
bracket only.
Fig. 4
Dovetail
Fig. 2
Vinyl Post
⁄ " drill bit. Remove template
1
16
Fig. 5
Template
Screw
Hole
Locations
COMPONENT LIST:
QTY Description
2 Brackets
2 Bracket Dovetails
6 #10 x 1" Flat Head Screws
1 Template
4 Pan Head Screws
Brackets
Screws
3 Place bracket inside the rails of the panel
until flush (fig. 3). If needed, tap with a
rubber mallet.
TIP: For fence rails that contain an insert,
ensure the inserts are pushed toward
center of rail and bracket fingers slide
behind them.
TEMPLATE BELOW PRINTED TO SCALE
PLEASE CUT OUT AND USE TO
DETERMINE SCREW HOLE LOCATIONS
Dovetail
Fig. 3
8196 3/15