Kit Assembly; Iso Din Radio Provision With Pocket - Metra 99-8300 Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Attach the corresponding bracket to the
radio housing trim panel. (Bracket #3
shown) (Figure A)
2. Secure the pocket to the bracket/ panel
assembly using the (4) #8 x 3/8" Phillips
screws supplied. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the assembly and
secure with the screws supplied with the
radio. (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS.
6. Secure the radio assembly into the
dash using the factory screws, then
reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 5/13/2020 INST99-8300
25