Maintenance And Cleaning - Wesen ECO 30 Instrucciones De Funcionamiento Y De Instalacion

EN
4 5
(1) On-off switch
Power selector. Smart function. Anti-legionella function. See (5)
(2)
(3) Temperature selector.
The digits will flash for 3 seconds. This means that the temperature has been success-
Display position (4) shows the desired temperature and also current water temperature.
The thermostat will automatically disconnect the electrical connection when the
used and the temperature falls below the predetermined value, the thermostat will
automatically reconnect the electrical supply.
ture, thereby ensuring significant savings in terms of electrical consumption.
and a flow rate of 6-8 litres per minute to obtain the best results from the appli-
ance. This device will protect against burns as the water from the heater can reach
avoid them.
Display position (5) shows the following four possibilities:
(5)
Position 1
Position 2
Position 3: SMART FUNCTION is activated. The system will identify your water usage
habits and adjust heating in order to minimize electrical consumption
Position 4: ANTI-LEGIONELLA FUNCTION is activated.
it pressed for 3 seconds
(6) The light remains on to indicate that the power supply is connected.
desired temperature the light will switch off.
6 7
3 2 1
– 8 –
SELF-DIAGNOSIS CODES:
[E2]
The water heater has been connected to the electricity supply before it was completely
filled with water, this could have damaged the device.
probably restore the device.
[E3]
[E4]

5. MAINTENANCE AND CLEANING

The water heater does not require any special maintenance and can be cleaned with a soft
-
Anode replacement
waters, that is to say, waters with excess lime or chloride.
The anode rods must be replaced when they show signs of being consumed or highly deg-
6. ENERGY EFFICIENCY. ERP AND ELD
The water heater WESEN ECO 30
efficiency of
wh=
The water heater WESEN ECO 50
EN
-
-
A
.