AERMEC KSAE Manual De Instrucciones página 5

KSAE fresh air probe
CONNECTING THE PROBE TO TERMINAL BOARD (WRL models)
FOR ELECTRICAL CONNECTION
ALWAYS REFER TO WIRING ON UNIT
(INCLUDED).
Product disposal
The device (or product) must be disposed of separately in accordance with local regulations regarding disposal.
IMPORTANT INSTRUCTIONS
The customer (manufacturer, designer or equipment installer) is held responsible for the risks related to the product installation stage to reach the expected results. Failure to
perform such study stage, which is requested/indicated in this instruction, may cause malfunctioning of the product, for which AERMEC shall not be held responsible. The final
customer must use the product only in the ways indicated in the documents supplied with the kit.
AERMEC S.p.A.
37040 Bevilacqua (VR) - Italy
Via Roma, 996 - Tel. (+39) 0442 633111
Telefax (+39) 0442 93730 – (+39) 0442 93566
www .aermec. com
KSAE
The technical data in the following documentation are not binding. Aermec reserves the right to make all the
modifications considered necessary for improving the product at any time.
EN
G
J1 - power supply
G0
+Vdc
J2 - probe supply
GND
+5 Vref
B1
B2
B3
B4
J3 - analog input
B5
B6
B7
GND
+Vdc
DI1
J6
DI2
DI3
DI4
J4 - digital input
DI5
DI6
DI7
DIC1
GND
Y1
J5 - analog output
Y2
Y3
Y4
B8
J18 - analog input
B9
B10
B11
J17 - valve 2
B12
GND
ID8
ID9
ID10 J16 - digital input
IDC2
J7
RX-/TX-
RX+/TX+
J8
GND
J9
J10 Vout
RX-/TX-
RX+/TX+
GND
J11
C1
NO1
J12 - group 1
NO2
NO3
C2
NO4
J13 - group 1
NO5
NO6
NO7
J14 - group 2 C3
NC7
C4
NO8
NO9
J15 - group 3
NO10
NO11
NO12