Telstar TVP016210MD Manual De Instrucciones página 8

OPERATING INSTRUCTION
I. Control Panel
On the control panel, there are two keys and six indicator lights. (See Fig.8)
1.
" " KEY
The key is for switching on the fan. The fan will be started at low speed.
Press the key again, the fan will work at middle speed.
Once again, it will work at the maximum speed. Once again, it will be switched off.
2.
" " KEY
This key is touched repeatedly or in pressed state. The time to be set for one hour, two hours and four hours.
Do not press the timer key when the fan will be required to operate continuously. At the moment all timer led
don't light.
II. Remote Control
On the remote control, there are three keys. (See Fig.9)
3.
" " KEY
After the fan has started, this key serves as a speed selector in the sequence from "low-medium-
high-low" when this key being touched repeated or continuously.
III. Oscillation Control
To make the fan oscillate, press the clutch knob located on the top of the motor housing. To get the directional
airflow, pull the clutch knob up to its initial position.
IV. Tilt Adjustment
To adjust the air flow upward or downward, push the grilles lightly to the desired direction.
V. Height Adjustment
The height of the fan can be adjusted by loosening the height adjustment ring carefully raising or lowering the
fan and firmly re-tightening the height adjustment ring.
8
STAND FAN
TVP016210MD
Fig.8
Fig.9