Cooper Lighting MS188 Manual De Instrucciones página 5

coming from your house to the copper ground wire from the fixture using wire
nut provided. If no house ground wire is available, attach the copper ground
wire from the fixture to the junction box if it is metal and grounded. If junction
box is not metal and no house ground wire is available, an alternative ground
source must be used for safe operation (Fig. 5).
3.
Attach fixture to the junction box with two of the screws (D) provided. Either (2)
#6 or (2) #8 screws will work with most standard junction boxes.
Wall Mount (Fig. 3)
Match up screws on the floodlight coverplate with
the junction box screw holes. (If necessary, lightly
tap selected coverplate holes with a hammer and
screwdriver to open them.) Attach fixture to junction box.
Eave Mount (Fig. 4)
Loosen screw which connects sensor arm to coverplate
arm. Rotate coverplate arm upwards, allowing stop on
coverplate arm to clear stop on sensor arm.
Note: Once stop on coverplate arm is above (to the left of) stop
on sensor arm, tighten screw. Be careful not to break stops.
4.
Apply silicone caulk around the edges of the coverplate to
provide a watertight seal from rain and moisture.
5.
Turn on power at mainfuse/breaker box.
HOW TO OPERATE YOUR FIXTURE
1.
Move slide switch on bottom of the sensor to "TEST".
Set sensitivity knob to medium (halfway) (Fig. 6).
2.
Turn on the power to fixture. Allow fixture to warm up
approximately 40 seconds before testing. (Lights will
come on and stay on during warm-up period.)
3.
Aim sensor head toward desired detection area,
maintaining a 15° down angle to allow moisture to drain.
Note: Maintain air spacing between lamp and sensor head,
at least 1˝. Make sure sensor head is positioned with control
switches facing towards the ground.
Call for customer service and/or missing or damaged parts (800-334-6871)
Lamp fixture
Black
lamp
fixture
wire
5
(wall mount)
(eave mount)
House
ground
ground
White
White
house
Black
lamp
power
house
fixture
wire
power
wire
wire
This is the bottom side
of the motion detector
SENSITIVITY
4 MIN 12 MIN
TEST
Fig. 3
Fig. 4
Fig. 5
Fig. 6