Uriflex Mickey Instrucciones página 14

Connecting the sensor briefs to the bedwetting alarm
The Mickey bedwetting alarm is wireless, so when the receiver is on and
the transmitter is clicked onto the sensor briefs, the bedwetting alarm is
ready for use.
Select the desired alarm signal
The Mickey offers 5 different alarms. At the back of the receiver you will
fi nd a button with the text "signal". Pressing this button, you will hear an
alarm sound. By pressing the button again, the signal changes automatically.
This way you can switch between up to 5 different signals. To select the
desired alarm release the button when you hear the signal of your choice.
Setting the volume
When pressing the volume button on the bottom of the receiver, you will
hear the volume as it is set on the bedwetting alarm. By keeping the button
pressed for a while the volume changes automatically. To select the desired
volume release the button when you hear the volume of your choice.
Low battery signal
On the back of the receiver you will fi nd a light that says "low battery".
If this (orange) light lights up, the battery of the transmitter must be replaced.
For instructions on how to open the transmitter, see previous page.
Error signal
When a red "error" light lights up on the back of the receiver this is an
indication that the transmitter and the receiver are not connected properly.
When wetting the bed the alarm will not go off.
In this case, please follow the following steps:
1. Remove the battery from the transmitter
2. Unplug the receiver from the plug socket
3. Wait 1 minute
4. Plug the receiver back into the plug socket
5. Place the battery back into the transmitter
If this doesn't help, you should repeat the steps 1 to 4. For step 5 please
use a new battery. Please contact our local offi ce (see www.urifl ex.com) if
the error light still lights up despite the new battery.
14
WWW.URIFLEX.COM URIFOON