Eaton E5324E Serie Instrucciones De Operación página 2

3. Setting of the parameters
3.1 Selecting the displayed value
By pressing the right key, the display can
be switched between the current, min., or
max. value.
Press the right key once to display the
current function ("Act", "Min" or "Max") for
2 seconds. If within this period the right
key is pressed again, the current function
is changed. The display shows the new
current function for two seconds.
Afterwards the corresponding value is dis-
played. If "Min" or "Max" is the current
function, the value can be reset by press-
ing the left key. If neither storing of min.
nor max. value is activated in setup, both
keys are out of function.
3. 2 Setting the operating parameters
a. Hold down both keys on front panel and
switch on the supply voltage.
b. The display shows:
c. After releasing the keys the display alternates
between menu title and corresponding menu
item at a frequency of 0.5 Hz. After any key is
pressed, only the menu item is displayed.
d. Press the right key to switch the menu item to
next value.
e. Hold down the left key and press the right key
to switch to the next menu title.
f. After programming the last menu item, the
programming routine will be exited and the
new values will be stored by switching the
menu item to "YES". If you choose "NO", the
programming routine will be passed through
once again.
2
4. Programming routine
Programmable parameters are shown in
succession. After one pass, the device is
fully programmed.
In each case the first shown item is the
factory preset.
4.1 Range of input signal
4.2 Max. value display
4.3 Max. value reset
4.4 Min. value display
0 – 20 mA
4 – 20 mA
0 – 10V
2 – 10V
Max. value can be
dis play ed
Max. value wonʼt be
dis play ed, next menu
title is skipped
Max. value can be reset
by pressing left button.
(Cur rent value becomes
new max. value)
Max. value canʼt be
reset.
Min. value can be displayed
Min. value wonʼt be
dis play ed, next menu
title is skip ped
MN05401008E