Spare Parts And Consumables; Troubleshooting - SKINERA MICRODERMABRASION Manual Del Usuario

2. Remove the rubber cap (#2), and then
EN
remove the filter (#3).
3. To clean the filter, brush off any debris, then
place it back on the device. To change a filter,
remove the current filter and insert a new one.
4. Place the rubber cap back into position,
then put the tip back on the device,
making sure that it is firmly connected.
Replacing the tip
We recommend that you replace the tip every six months, or
earlier if the abrasive end of the tip is damaged.

Spare parts and consumables

You can order more filters and tips from our website:
www.inno-webshop.com. For replacement rubber caps or
AC/DC adapters, please contact our Customer Service.

Troubleshooting

Do not attempt to open or repair your Skinera Microdermabrasion.
You may expose yourself to dangerous electrical components and
cause serious harm to yourself. It will also void the warranty.
12
3
2