Vollrath CBT15 Manual Para Operadores página 2

FEATURES
J
K
A Platen (Under the release sheet).Toasts the cut side of the bun
B Release Sheet. Prevents buns from sticking to platen.
C Platen Adjustment. Adjusts the compression on the front slot.
D Heat Control Knob
E Front Slot Speed Control
F Rear Slot Speed Control
G Power LED. Illuminates when power to the toaster is ON.
H On/OFF1 Switch
I Collection Pan
J Reset Button
K Platen Adjustment. Adjusts the compression on the rear slot.
2
OPERATION
A
CAUTION
B
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
C
NOTICE: The release sheet must be installed over the platen during
operation. Failure to install the release sheet may damage
D
the toaster and void the warranty.
E
Preheat
F
1. Plug the toaster into a grounded electrical outlet that matches the
G
rating on the name plate found on the side of the toaster.
H NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Rotate the platen adjustment knobs for each slot to accommodate
the bun to be toasted.
I 3. Switch the power switch to the ON position.
4. Set the speed control knobs to 7.
5. Rotate the heat control knob to the highest setting.
6. Wait 30-45 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted. Test the settings by
placing a sample of the buns to be toasted onto the slots at the top
of the toaster with the cut side facing the platen.
2. Evaluate the results.
Toast Buns
1. Adjust the heat control and conveyor speed settings as needed.
Allow time for the toaster to adjust to new heat
If a Bun Becomes Stuck
1. Switch the power switch to the OFF position.
2. Let the toaster cool completely.
3. Use tongs to remove the bread item.
Vertical Contact Toaster Operator's Manual – Model CBT15
settings.