Stenner SVP Serie Manual De Instalación Y Mantenimiento página 20

TROUBLESHOOTING – PUMP HEAD
PROBLEM
Components cracking
Pump head leaking
No pump output,
pump head rotates
Low pump output,
pump head rotates
No pump output,
pump head doesn't rotate
Pump output high
20
POSSIBLE CAUSE
Chemical attack
Pump tube rupture
Depleted solution tank
Pump suction line weight is
above solution
Leak in the suction line
Ferrules installed incorrectly,
missing or damaged
Injection point is clogged
Clogged suction/discharge line
and/or injection check valve
Life of pump tube exhausted
Suction line is flush with
the nose of the weighted strainer
Life of pump tube exhausted
Rollers worn or broken
Injection point is restricted
Incorrect tube size
High system back pressure
Stripped roller assembly
Motor problem
Incorrect tube size or setting
Roller assembly broken
www.stenner.com
SOLUTION
Check chemical compatibility
Replace pump tube, ferrules; center tube
Replenish solution
Maintain suction line 2-3" above
bottom of tank
Inspect or replace suction line
Replace ferrules
Inspect and clean injection point
Clean and/or replace as needed
Replace pump tube, ferrules; center tube
Pull suction line approximately 1" from
bottom of strainer, cut bottom of suction
tubing at an angle
Replace pump tube, ferrules; center tube
Replace roller assembly
Inspect and clean injection point
Replace tube with correct size
Verify system pressure against tube psi,
replace tube if needed
Replace roller assembly
Refer to motor section
Replace tube with correct size
Replace roller assembly