En: Installation Sheet - Interlogix AS500 Serie Hoja De Instalación

6

EN: Installation Sheet

Description
The AS500 series siren is an outdoor siren with a beacon.
Wiring
First, wire the control panel (power down) to the siren as
shown above, before connecting the battery. When the battery
is connected for the first time, the siren will give a short beep.
The siren cannot be activated until all inputs (input power and
hold-off voltages) are correct. The siren will be activated if the
input power is removed or drops significantly or if the siren
hold-off voltage is removed.
Specifications
Supply*
Current
Standby
Operating
Sound output
Frequency
Cut-off timer
Battery:
Type
Load voltage
Tamper
Weight
Dimensions
P/N 144163999-2 (ML) • REV D • ISS 29MAR19
10.0 to 14.5 V
40 mA typical
350 mA typical (including beacon)
114 dB at 1 m, 85 dB at 3 m
1.8 to 3 kHz
Preset at 3 min.
Adjustable 5, 10, 20 min.
Lead acid, BS121N, 12 V, 1.2 Ah
13.6 to 14.2 V
28 V , 100 mA max.
1 kg
210 x 300 x 70 mm
Working temperature
Beacon
Operating current
Light output
Life time
Flash rate
Spike suppression network
* To be connected to an external current limited power supply.
(Advised: 5 A).
Battery removal / disposal
This product may contain one sealed, rechargeable, BS-type
lead-acid battery. Because removing batteries may affect the
product's configuration settings or trigger an alarm, only a
qualified installer should remove them.
To remove the battery:
1. Make sure that your product settings allow you to open its
cover without starting the tamper alarm.
2. Switch off the mains power, if necessary, and remove the
cover.
3. Disconnect battery connectors.
4. Remove the battery from the holder.
For proper recycling, dispose of all batteries as required by
local ordinances or regulations.
WARNING: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer.
Regulatory information
Manufacturer PLACED ON THE MARKET BY:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
AUTHORIZED EU REPRESENTATIVE:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
Product warnings THESE PRODUCTS ARE INTENDED FOR SALE
and disclaimers TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY "AUTHORIZED
DEALER" OR "AUTHORIZED RESELLER", IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
European Union UTC Fire & Security hereby declares that this
directives device is in compliance with the applicable
requirements and provisions of the Directive
2014/30/EU and/or 2014/35/EU. For more
information see www.utcfireandsecurity.com or
www.interlogix.com.
−25 to +55°C (no battery)
0 to +40°C (with battery)
110 mA
100.000 peak lumens
1.000.000 flashes
60/minute
Standard fitted
or scan the QR code.
3 / 10